INA219 Current Sensor DIY Breakout board

Another small board, this time for a INA219. The INA219 is a high-side current shunt and power monitor with an I2C interface.

INA219

For testing I used Rei VILO library with a MSP430G2553 and Energia, and I measured the power consumption for this simple circuit:

2 001-001

Nothing fancy, just a led and a resitor. The INA219 should measure around 9.6 mA and got this:

led_5v_330R

The current measurement is slightly off. I need to play a litlle more with the calibration routines.

 

Advertisements

SHT21S DIY Breakout board

I made a little board for a SHT21 humidity and temperature sensor from Sensirion.  There are several versions with I2C interface, PWM output and SMD/analog interface.

I’ve got the one with Sigma Delta Modulation (SMD) output,  is a bit-stream of pulses; the more high pulses the higher the value in the full measurement range. A low-pass filter convert the pulse stream to an analog voltage signal.

It has a control pin (SCL) to select between humidity or temperature output. SCL high yields humidity output, SCL low yields temperature output.

SHT21S

I made a simple sketch in Energia to test it out using an MSP430G2553. P1.6 selects between humidity or temperature and P1.0 is used as the ADC input.

SHT21S

…and logged both temperature an humidity.

Sin título

That’s it, a simple and nice sensor…